3d Printing

I finally got my 3d printer put back together after a few additions.  I added a a new PSU along with a MOSFET for the heat bed.  The MOSFET is to remove the added stress from the main board so as not to cause an electrical fire.  Instructions on how to wire the MOSFET can be found on the 3d Wiki Page.  I then added another safety feature, a fused switch.  But first I had to print a switch cover for the PSU.  Once I got that installed, I am now ready to go printing...

I can say that I been busy.  All items that I have printed thus far have been from Thingiverse website.

This is my Sci-Fi starship console that I will be using in my wargaming scenarios.  When I get them all printed and painted I will put them up on my blod, but until then, it's happy 3d printing for this guy...